Color Black + Dark Blue + Multi-Colored Brand ZnDiy-BRY Model All-in-one V2.0 Material PCB + plastic Quantity 1 Piece Compatible Model Flight controller Other Features With side pins; Supported MegaPirateNG / ArduCopterNG ArduPlaneNG / MultiWii / AeroQuadand firmware; Up to 8-axis motor output; 8 input channels for standard receiver and PPM SUM; 4 serial ports for debug / Bluetooth Module / OSD / GPS / telemetry; 2 servos output for PITCH and ROLL gimbal system; A servos output to trigger a camera button; 6 Analog output for extend device; A I2C port for extend sensor or device; Separate 3.3V and 5V LDO voltage regulator; Built-in 16Mbit data flash memory chip to record the data automatically; ATMega 2560-16AU Microcontroller; MPU6050 6 axis gyro / accel with Motion Processing Unit; HMC5883L 3-axis digital magnetometer; MS5611-01BA01 highprecision altimeter; FT232RQ USB-UART chip and Micro USB receptacle; On board logic level converter. Input power selection: One of the following ways; Connect 5V power cable from ESC or UBEC to the ESC/Servo port the J1 jumper must be closed. Connect 5V~12V power cable to the extend power port the J1 jumper must be removed. When using Extend Board AIO PRO must be powered from the extend power port Packing List 1 x Flight controller 1 x 3-Pin to 3-Pin cable (10cm) 3 x 3-Pin to 1-Pinx3 cables (10cm) 1 x 1.25mm 4-Pin cable (14cm) 1 x 1.25mm 6-Pin cable (14cm) 1 x 1.25mm 8-Pin cable (14cm)